Toyota Hilux 3.0 Diesel 2014 - OEX DXA552M Alternator 12V 130A (Check Fitment)

OEX DXA552M Alternator 12V 130A - Denso Style RESEARCHED APPLICATIONS - FITMENT CONFIRMATION REQUIRED Main researched application: Toyota Hilux, 2014, 3.0L diesel. DXA552M appeared in the Prolink vehicle lookup. The exact Hilux chassis/engine code and full production date range were not retained in the collected lookup, so this is not a blanket fitment claim for all Hilux models. Additional researched application: Toyota Hiace ZL, 2014, 3.0L diesel. The selected Prolink vehicle was TOYOTA HIACE KDH201/KDH221, 3.0L 1KD-FTV, DOHC 16-valve turbo diesel direct injection, 4-cylinder, 80kW, van, rear-wheel drive, catalogue production range November 2006 to January 2019. This range describes the selected catalogue vehicle; confirm the exact alternator application before ordering. Confirm VIN/chassis, engine, original alternator/OE part number, connector (IR115), mounting, pulley alignment and required output before supply. No OE cross-reference was captured in this research. A registration lookup alone does not confirm fitment. OUTPUT AND INSTALLATION RESTRICTIONS The researched vehicle lookups also offered an 85A alternator. This DXA552M is rated 130A. If replacing an 85A unit, the supplier recommends upgrading the alternator-to-battery cable and fuse. Check the original equipment and installation requirements; do not assume a direct replacement without these checks. OEX Alternator 12V 130A Denso Style - See Note • If the alternator warning lamp flickers during acceleration or deceleration, the issue may be related to a faulty ECM, not just the alternator. • If replacing the 85A alternator with either the 130A or 160A unit, it is recommended to upgrade battery cable and fuse from alternator to battery. • If the alternator cannot be fitted to the fixed mount on the engine block, the previous alternator bolt may have been overtightened, causing the bushes to be pushed in. • Push the bushes back out before fitting the replacement alternator. Adjusting Hole Diameter: M8x1.25 Mount Leg Thickness: 58mm Pin Code: IR115 Power Rating [Amp]: 130 Pulley Outside Diameter: 58mm Pulley Section: 7 Groove Regulator Type: Internal Rotation: CW Suits Unit Make: Denso Voltage: 12 Alternator Mount: Single Leg Item Type: Alternator Mount Cnt to Cnt: 165mm New / Reman.: New Weight: 6.5kg Installation notes: If the alternator warning lamp flickers during acceleration or deceleration, the issue may be related to a faulty ECM, not just the alternator. If replacing the 85A alternator with either the 130A or 160A unit, it is recommended to upgrade battery cable and fuse from alternator to battery. If the alternator cannot be fitted to the fixed mount on the engine block, the previous alternator bolt may have been overtightened, causing the bushes to be pushed in. Push the bushes back out before fitting the replacement alternator. Warranty: 3yr Passenger 1yr Commercial